HP VPN Firewall Appliances System Management and Maintenance Command Reference

106
Destination
Source
modules
Lo
g
Tra
p
Debu
g
Status Severit
y
Status Severit
y
Status Severit
y
Log file
All
supported
modules
Enabled Debug Enabled Debug Disabled Debug
Examples
# Output VLAN module's trap information with a severity level of at least emergency to the channel
console. All other system information cannot be output to this channel.
<Sysname> system-view
[Sysname] info-center source default channel console debug state off log state off trap
state off
[Sysname] info-center source vlan channel console trap level emergencies state on
info-center synchronous
Use info-center synchronous to enable synchronous information output.
Use undo info-center synchronous to disable synchronous information output.
Syntax
info-center synchronous
undo info-center synchronous
Default
Synchronous information output is disabled.
Views
System view
Default command level
2: System level
Usage guidelines
If system information is output before you enter information at a command line prompt, the system does
not display the command line prompt after the system information output.
If system information is output when you are entering some interactive information (non Y/N confirmation
information), the system displays your input in a new line after the system information output.
Examples
# Enable synchronous information output, and then execute the display current-configuration command
to view the current configuration of the device.
<Sysname> system-view
[Sysname] info-center synchronous
% Info-center synchronous output is on
[Sysname] display current-
At this time, the system receives log information. It displays the log information first, and then displays
your previous input, which is display current- in this example.
%May 21 14:33:19:425 2007 Sysname SHELL/4/LOGIN: VTY login from 192.168.1.44