HP VPN Firewall Appliances System Management and Maintenance Command Reference

254
Syntax
open ipv6 server-address [ service-port ] [ -i interface-type interface-number ]
Views
FTP client view
Default command level
3: Manage level
Parameters
server-address: IP address or host name of the remote FTP server.
service-port: Port number of the remote FTP server, in the range of 0 to 65535. The default value is 21.
-i interface-type interface-number: Specifies an output interface by its type and number. This parameter
can be used only when the FTP server address is a link local address and the specified output interface
has a link local address. For the configuration of link local addresses, see the chapter on IPv6 basics in
Network Management Configuration Guide.
Usage guidelines
At login, enter the username and password for accessing the FTP server. If your input is correct, the login
succeeds.
Examples
# Log in to the FTP server at 3000::200 in FTP client view.
<Sysname> ftp
[ftp] open ipv6 3000::200
Trying 3000::200 ...
Press CTRL+K to abort
Connected to 3000::200.
220 Welcome!
User(3000::200:(none)): MY_NAME
331 Please specify the password.
Password:
230 Login successful.
[ftp]
Related commands
close
passive
Use passive to set the FTP operation mode to passive.
Use undo passive to set the FTP operation mode to active.
Syntax
passive
undo passive
Default
The FTP operation mode is passive.