HP VPN Firewall Appliances System Management and Maintenance Configuration Guide

149
packets : 9 , broadcast packets : 2
multicast packets : 6 , CRC alignment errors : 0
undersize packets : 0 , oversize packets : 0
fragments : 0 , jabbers : 0
collisions : 0 , utilization : 0
Sampled values of record 7 :
dropevents : 0 , octets : 766
packets : 7 , broadcast packets : 0
multicast packets : 6 , CRC alignment errors : 0
undersize packets : 0 , oversize packets : 0
fragments : 0 , jabbers : 0
collisions : 0 , utilization : 0
Sampled values of record 8 :
dropevents : 0 , octets : 1154
packets : 13 , broadcast packets : 1
multicast packets : 6 , CRC alignment errors : 0
undersize packets : 0 , oversize packets : 0
fragments : 0 , jabbers : 0
collisions
: 0 , utilization : 0
# On the configuration terminal, get the traffic statistics through SNMP. (Details not shown.)
Alarm group configuration example
Network requirements
Configure the RMON alarm group on the firewall (the RMON agent) in Figure 66 to send alarms in traps
when the 5-second incoming traffic statistic on GigabitEthernet 0/1 crosses the rising threshold or drops
below the falling threshold.
Figure 66 Network diagram
Configuration procedure
# Configure the SNMP agent with the same SNMP settings as the NMS at 1.1.1.2. This example uses
SNMPv1, read community public, and write community private.
<Firewall> system-view
[Firewall] snmp-agent
[Firewall] snmp-agent community read public
[Firewall] snmp-agent community write private
[Firewall] snmp-agent sys-info version v1
Terminal
Firewall
NMS
Console
Server
GE0/1
1.1.1.2/24