HP VPN Firewall Appliances System Management and Maintenance Configuration Guide

195
[Router] public-key peer ClientKey import sshkey key.pub
# Create an SSH user client002, and specify the authentication method for the user as publickey,
and assign the public key ClientKey to the user.
[Router] ssh user client002 service-type stelnet authentication-type publickey assign
publickey ClientKey
3. Establish an SSH connection to the Stelnet server 192.168.1.40.
<Firewall> ssh2 192.168.1.40
Username: client002
Trying 192.168.1.40 ...
Press CTRL+K to abort
Connected to 192.168.1.40 ...
The Server is not authenticated. Continue? [Y/N]:y
Do you want to save the server public key? [Y/N]:n
Then, you can log in to the router successfully.
SFTP configuration examples
Password authentication enabled SFTP server configuration
example
Network requirements
As shown in Figure 88, you can log in to the firewall through the SFTP client that runs on the host. The
firewall acts as the SFTP server and uses password authentication. The username and password of the
client are saved on the firewall.
Figure 88 Network diagram
Configuration procedure
1. Configure the SFTP server:
# Generate the RSA key pairs.
<Firewall> system-view
[Firewall] public-key local create rsa
The range of public key size is (512 ~ 2048).
NOTES: If the key modulus is greater than 512,
It will take a few minutes.
Press CTRL+C to abort.
Input the bits of the modulus[default = 1024]:
Generating Keys...
++++++++
++++++++++++++