HP VPN Firewall Appliances System Management and Maintenance Configuration Guide

234
• 3132 3334 corresponds to the username 1234 .
• 35 3637 38 corresponds to the password 5678.
• 20 is the end delimiter.
For more information about DHCP, DHCP Option 43, and the option command, see Network
Management Configuration Guide.
Configuring CWMP at the CLI
Some tasks in this section can also be performed on the ACS or DHCP server. For a CWMP parameter,
the setting assigned by the ACS has the same priority as the CLI setting, and the setting issued by the
DHCP server has lower priority than the CLI setting. The ACS-assigned setting and the CLI setting override
each other, and whichever is configured the last takes effect.
Complete the following tasks to configure CWMP at the CLI:
Task Remarks
Enabling CWMP Required.
Configuring ACS attributes:
• Configuring the ACS URL
Required.
Supports configuration through ACS,
DHCP, and CLI.
• Configuring the ACS username and password
Optional.
Supports configuration through ACS,
DHCP, and CLI.
Configuring CPE attributes:
• Configuring the CPE username and password
Optional.
Supports configuration through ACS and
CLI.
• Configuring the CWMP connection interface
Optional.
Supports configuration through CLI only.
• Sending Inform messages
Optional.
Supports configuration through ACS and
CLI.
• Configuring the maximum number of attempts made to retry a
connection
Optional.
Supports configuration through CLI only.
• Configuring the close-wait timer of the CPE
Optional.
Supports configuration through CLI only.
• Configuring the CPE working mode
Optional.
Supports configuration through CLI only.
• Specifying an SSL client policy for HTTPS connection to ACS
Optional.
Supports configuration through CLI only.