HP VPN Firewall Appliances System Management and Maintenance Configuration Guide

236
Ste
p
Command Remarks
4. Configure the ACS password
for connection to the ACS.
cwmp acs password
[ cipher | simple ]
password
Optional.
You can specify a username without a
password for authentication, but must
make sure the ACS has the same
authentication setting as the CPE.
By default, no ACS password is configured
for connection to the ACS.
Configuring CPE attributes
CPE attributes include CPE username and password, which a CPE uses to authenticate the validity of an
ACS. When an ACS initiates a connection to a CPE, the ACS sends a session request carrying the CPE
URL, username, and password. When the device (CPE) receives the request, it compares the CPE URL,
username, and password with those configured locally. If they are the same, the ACS passes the
authentication of the CPE, and the connection establishment proceeds. Otherwise, the authentication
fails, and the connection establishment is terminated.
Configuring the CPE username and password
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter CWMP view.
cwmp N/A
3. Configure the CPE username
for connection to the CPE.
cwmp cpe username
username
By default, no CPE username is
configured for connection to the CPE.
4. Configure the CPE password
for connection to the CPE.
cwmp cpe password [ cipher
| simple ] password
Optional.
You can specify a username without a
password for authentication, but make
sure the ACS has the same authentication
setting as the CPE.
By default, no CPE password is
configured for connection to the CPE.
Configuring the CWMP connection interface
The CWMP connection interface is the interface that the CPE uses to communicate with the ACS. The CPE
sends the IP address of this interface in the Inform messages and the ACS replies to this IP address for
setting up a CWMP connection.
If the interface that connects the CPE to the ACS is the only Layer 3 interface that has an IP address on
the device, you do not need to specify the CWMP connection interface. If multiple Layer 3 interfaces are
configured, specify the CWMP connection interface to make sure the IP address of the interface that
connects to the ACS is sent to the ACS for setting up CWMP connection.
To configure a CWMP connection interface: