HP VPN Firewall Appliances System Management and Maintenance Configuration Guide

237
Ste
p
Command
1. Enter system view.
system-view
2. Enter CWMP view.
cwmp
3. Set the interface that connects the CPE to the
ACS.
cwmp cpe connect interface interface-type
interface-number
Sending Inform messages
Inform messages need to be sent during the connection establishment between a CPE and an ACS. You
can configure the Inform message sending parameter to trigger the CPE to initiate a connection to the
ACS.
To configure the CPE to periodically send Inform messages:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter CWMP view.
cwmp N/A
3. Enable the periodic sending
of Inform messages.
cwmp cpe inform interval enable By default, this function is disabled.
4. Configure the interval
between sending the Inform
messages.
cwmp cpe inform interval seconds
Optional.
By default, the CPE sends an Inform
message every 600 seconds.
To configure the CPE to send an Inform message at a specific time:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter CWMP view.
cwmp N/A
3. Configure the CPE to send an
Inform message at a specific
time.
cwmp cpe inform time time
By default, no time is set. The CPE
is not configured to send an Inform
message at a specific time.
Configuring the maximum number of attempts made to retry a
connection
If a CPE fails to establish a connection to an ACS or the connection is interrupted during the session (the
CPE does not receive a message indicating the normal close of the session), the CPE can automatically
reinitiate a connection to the ACS.
To configure the maximum number of attempts that the CPE can make to retry a connection:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter CWMP view.
cwmp N/A