HP VPN Firewall Appliances System Management and Maintenance Configuration Guide

68
Field Descri
p
tion
Sysname (host name or
host IP address)
• If the system information that is sent to a log host is in the UNICOM format, and
the info-center loghost source command is configured, or the vpn-instance
vpn-instance-name option is provided in the info-center loghost command, the
sysname field is displayed as the IP address of the device that generated the
system information.
• If the system information is in the HP format, the field is displayed as the system
name of the device that generated the system information. You can use the
sysname command to modify the local system name. For more information, see
Getting Started Command Reference.
%% (vendor ID)
This field indicates that the information was generated by an HP device.
It exists only in system information sent to a log host.
vv (version information)
This field identifies the version of the log, and has a value of 10.
It exists only in system information sent to the log host.
Module
This field specifies source module name. You can execute the info-center source ?
command in system view to view the module list.
Level (severity)
System information is divided into eight severity levels, from 0 to 7. See Table 7 for
more information about severity levels. You cannot change the system information
levels generated by modules. However, you can use the info-center source
command to control the output of system information based on severity levels.
Digest
This field briefly describes the content of the system information. It contains a string
of up to 32 characters.
For system information destined to the log host:
• If the string ends with (l), the information is log information.
• If the string ends with (t), the information is trap information.
• If the string ends with (d), the information is debug information.
Serial Number
This field indicates the serial number of the device that generated the system
information. It is displayed only if the system information sent to the log host is in
the UNICOM format.
source
This optional field identifies the source of the information. It exists only in system
information that is sent to a log host in HP format. Typically, this field displays the
IP address of the log sender.
content This field contains the content of the system information.
version
Syslog version, which must be 1. It exists only in system information in
china-telecom or china-unicom-nat444 format sent to the log host.
hostip
Source IP address of the system information. When info-center loghost source is
configured, this field displays the IP address of the specified source interface.
Otherwise, this field displays a hyphen (-). It exists only in system information in
unicom, china-telecom, or china-unicom-nat444 format sent to the log host.
msgid ( messae type)
Message type, which
• Starts with DSLITE for china-telecom format.
• Starts with NAT444 for china-telecom or china-unicom-nat444 format.