HP VPN Firewall Appliances System Management and Maintenance Configuration Guide

71
Ste
p
Command Remarks
9. Enable the display of system
information on the console.
• Enable the display of debug
information on the console:
terminal debugging
• Enable the display of log
information on the console:
terminal logging
• Enable the display of trap
information on the console:
terminal trapping
Optional.
By default, the console displays log
and trap information, and discards
debug information.
Outputting system information to the monitor
terminal
Monitor terminals refer to terminals that log in to the device through the AUX, VTY, or TTY user interface.
To output system information to the monitor terminal:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enable the information center.
info-center enable
Optional.
Enabled by default.
3. Specify a name for a channel
identified by its number.
info-center channel
channel-number name
channel-name
Optional.
See Table 8 for
default channel
names.
4. Configure an output channel
for the monitor terminal.
info-center monitor channel
{ channel-number |
channel-name }
Optional.
By default, system information is
output to the monitor terminal
through channel 1 (known as
monitor).
5. Configure an output rule for
the monitor terminal.
info-center source { module-name |
default } channel { channel-number
| channel-name } [ debug { level
severity | state state } * | log { level
severity | state state } * | trap
{ level severity | state state } * ] *
Optional.
See "Default output rules of system
information."
6. Configure the timestamp
format.
info-center timestamp { debugging
| log | trap } { boot | date | none }
Optional.
By default, the timestamp format
for log, trap and debug
information is date.
7. Return to user view.
quit N/A