HP VPN Firewall Appliances System Management and Maintenance Configuration Guide

73
Ste
p
Command Remarks
7. Set the system
information format.
• Set the format to unicom:
info-center format unicom
• Set the format to china-telecom:
info-center format
china-telecom
• Set the format to
china-unicom-nat444:
info-center format
china-unicom-nat444
• Set the format to HP:
undo info-center format
Optional.
The default setting is HP.
The china-telnetcom and
china-unicom-nat444 formats are
available only for NAT444. For more
information about NAT444, see NAT
and ALG Configuration Guide.
8. Specify a log host and
configure related
parameters.
info-center loghost [ vpn-instance
vpn-instance-name ]
{ host-ipv4-address | ipv6
host-ipv6-address } [ port
port-number ] [ channel
{ channel-number | channel-name }
| facility local-number ] *
By default, no log host or related
parameters are specified.
If no channel is specified when
outputting system information to a log
host, the system uses channel 2
(loghost) by default.
The value of the port-number argument
must be the same as the value
configured on the log host. Otherwise,
the log host cannot receive system
information.
The following matrix shows support for outputting system information in china-unicom-nat444 or
china-telecom format to a log host on different firewalls and firewall modules:
Hardware
Outputting system information in
china-unicom-nat444 or china-telecom format
to a lo
g
host
F1000-A-EI/F1000-S-EI No
F1000-E No
F5000 No
F5000-S/F5000-C No
VPN firewall modules Yes
20-Gbps VPN firewall modules Yes
Outputting system information to the trap buffer
The trap buffer only receives trap information, and discards log and debug information.
To output system information to the trap buffer:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A