HP VPN Firewall Appliances System Management and Maintenance Configuration Guide

76
Outputting system information to the Web interface
The Web interface only receives log information, and discards trap and debug information.
This feature allows you to control whether to output system information to the Web interface and, if so,
which system information can be output to the Web interface. The Web interface provides abundant
search and sorting functions. If you output system information to the Web interface, you can view the
system information by clicking corresponding tabs after logging in to the device through the Web
interface.
To output system information to the Web interface:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enable the information center.
info-center enable
Optional.
Enabled by default.
3. Specify a name for a channel
identified by its number.
info-center channel
channel-number name
channel-name
Optional.
See Table 8 for
default channel
names.
4. Configure an output channel
for the Web interface.
info-center syslog channel
{ channel-number |
channel-name }
Optional.
By default, system information is
output to the Web interface
through channel 6.
5. Configure an output rule for
the Web interface.
info-center source { module-name |
default } channel { channel-number
| channel-name } [ debug { level
severity | state state }* | log { level
severity | state state }* | trap
{ level severity | state state }* ]*
Optional.
See "Default output rules of system
informa
tion."
6. Configure the timestamp
format.
info-center timestamp { debugging
| log | trap } { boot | date | none }
Optional.
The timestamp format for log, trap
and debug information is date by
default.
Saving system information to the log file
The following matrix shows support for the log file feature on different firewalls and firewall modules:
Hardware Out
p
uttin
g
s
y
stem information to the lo
g
file
F1000-A-EI/F1000-S-EI No
F1000-E Yes
F5000 Yes
F5000-S/F5000-C Yes
VPN firewall modules Yes