HP VPN Firewall Appliances VPN Configuration Guide

194
After the configuration, Firewall A, Firewall B, and Firewall C learn IPv6 routing information
through RIPng. SAs are set up successfully, and the IPsec tunnel between two peers is up for
protecting the RIPng packets.
# Execute the display ripng command on Firewall A to view the running status and configuration
information of the specified RIPng process. The output shows that IPsec policy policy001 is applied
to this process successfully.
<FirewallA> display ripng 1
RIPng process : 1
Preference : 100
Checkzero : Enabled
Default Cost : 0
Maximum number of balanced paths : 8
Update time : 30 sec(s) Timeout time : 180 sec(s)
Suppress time : 120 sec(s) Garbage-Collect time : 120 sec(s)
Number of periodic updates sent : 186
Number of trigger updates sent : 1
IPsec policy name: policy001, SPI: 123456
# Execute the display ipsec sa command on Firewall A to view the information about the inbound
and outbound SAs.
<FirewallA> display ipsec sa
===============================
Protocol: RIPng
===============================
-----------------------------
IPsec policy name: "policy001"
sequence number: 10
acl version: ACL4
mode: manual
-----------------------------
connection id: 1
encapsulation mode: transport
perfect forward secrecy:
tunnel:
flow:
[inbound ESP SAs]
spi: 123456 (0x3039)
transform-set: ESP-ENCRYPT-DES ESP-AUTH-SHA1
No duration limit for this sa
[outbound ESP SAs]
spi: 123456 (0x3039)
transform-set: ESP-ENCRYPT-DES ESP-AUTH-SHA1
No duration limit for this sa
Similarly, you can view the information on Firewall B and Firewall C. (Details not shown.)