HP VPN Firewall Appliances VPN Configuration Guide

211
Figure 142 IPsec VPN policy configuration wizard: 2/4 (branch node)
5. Perform configuration as described in Table 16.
Table 16 Configuration items
Item Descri
p
tion
IPSec VPN Name
Enter the name for the IPsec VPN.
IMPORTANT:
If you enter abc here, the wizard creates an IKE peer named abc_peer, an IPsec
proposal named abc_prop, and an IPsec policy named abc_poli and numbered
1. The IKE peer and IPsec proposal are referenced in the IPsec policy.
IPSec Interface Select the interface to which you want to apply the IPsec policy.
Center IP Address
Enter the IP address of the center node, which is used during IKE negotiation.
IMPORTANT:
The IP address specified here must match the local IP address specified on the
peer.
Center Gateway Name
Enter the name of the remote gateway at the center node, which is used during
IKE negotiation.
Identity
Configuration
Local IP
Address
Specify the ID type of the local end for IKE negotiation phase 1. Options
include:
• Local IP Address—Uses the IP address of the local gateway as the ID. If you
do not specify the IP address, the default (the primary IP address of the
interface using the security policy) is used.
• Local Gateway Name—Uses the name of the local gateway as the ID. If
you do not specify the gateway name, the default (the device name) is
used.
Local
Gateway
Name
6. Click Next.