HP VPN Firewall Appliances VPN Configuration Guide

215
5. Perform configuration as described in Table 18.
Table 18 Configuration items
Item Descri
p
tion
IPSec VPN Name
Enter the name for the IPsec VPN.
IMPORTANT:
If you enter abc here, the wizard creates an IKE peer named abc_peer, an IPsec
proposal named abc_prop, and an IPsec policy named abc_poli and numbered
1. The IKE peer and IPsec proposal are referenced in the IPsec policy.
IPSec Interface Select the interface to which you want to apply the IPsec policy.
Remote IP Address
Enter the remote IP address for IKE negotiation.
IMPORTANT:
The IP address specified here must match the local IP address specified on the
peer.
Identity
Configuration
Local IP
Address
Specify the ID type of the local end for IKE negotiation phase 1. Options
include:
• Local IP Address—Uses the IP address of the local gateway as the ID. If you
do not specify the IP address, the default (the primary IP address of the
interface using the security policy) is used.
• Local Gateway Name—Uses the name of the local gateway as the ID. This
option is not available because the local end cannot use its local gateway
name for IKE negotiation when the peer node uses the negotiation mode of
main.
Local
Gateway
Name
6. Click Next.
Figure 147 IPsec VPN policy configuration wizard: 3/4 (peer node)
7. Perform configuration as described in Table 19.