HP VPN Firewall Appliances VPN Configuration Guide

231
Specifying an IP address pool
1. Click Add for User Address in Figure 158.
Figure 161 Adding an address pool
2. Specify an address pool for assigning IP addresses to PPP users, as described in Table 23.
3. Click Apply.
Table 23 Configuration items
Item Descri
p
tion
ISP Domain
Select the ISP domain for the IP address pool to be created.
If no ISP domain is specified, the address pool is used to allocate IP addresses to
PPP users that do not need authentication.
IP Address Pool Number
Specify the number of the IP address pool.
If you set the IP address pool number to 1, the name of the IP address pool is
pool1.
Start IP
Specify the start IP address and end IP address of the IP address pool.
The number of addresses between the start IP address and end IP address must not
exceed 1024. If you specify only the start IP address, the IP address pool will
contain only one IP address—the start IP address.
End IP
Displaying L2TP tunnel information
Select VPN > L2TP > Tunnel Info from the navigation tree to enter the L2TP tunnel information page, as
shown in Figure 162. Table 24 describes the f
ields on the page.
Figure 162 L2TP tunnel information