HP VPN Firewall Appliances VPN Configuration Guide

34
4. Configure a static route from Firewall A through interface Tunnel0 to the branch network:
a. Select Network > Routing Management > Static Routing from the navigation tree.
b. Click Add.
c. Enter 192.168.12.0 as the destination IP address.
d. Select mask 255.255.255.0.
e. Select Tunnel0 as the outbound interface.
f. Click Apply.
Figure 33 Adding a static route from Firewall A through interface Tunnel0 to the branch network
Configuring Firewall B
1. Configure an IPv4 address for each interface and assign the interfaces to security zones. (Details
not shown.)
2. Create a P2MP GRE tunnel interface, with the tunnel interface number being 0:
a. Select VPN > GRE > P2MP from the navigation tree.
b. Click Add.
c. Enter 0 in the Tunnel Interface field, and enter IP address/mask 172.168.2.2/24.
d. Select Management from the Zone list. (Select a security zone according to your network
configuration.)
e. Enter 11.1.1.2 as the tunnel source address, 24 as the branch network address mask, and 10
as the tunnel entry aging time.
f. Click Apply.