HP VPN Firewall Appliances VPN Configuration Guide

428
g. Enter the network address 10.0.2.0, select the network mask 0.0.0.255, and then click Add
Network.
h. Click Apply.
i. Click More>> to perform OSPF interface configuration.
j. Click the icon of Tunnel1.
Figure 328 Configuring OSPF interface
k. Select Broadcast as the network type and click Apply.
l. Repeat steps i through k to configure the same settings for interface Tunnel2.
Configuring Hub 2
Figures are omitted.
1. Configure IP addresses for the interfaces. (Details not shown.)
2. Configure tunnel interface Tunnel1 for VPN domain vpn1:
a. From the navigation tree, select VPN > DVPN > Client, and then click Add.
b. Select the tunnel encapsulation mode UDP, enter the tunnel interface number 1, enter the IP
address/mask 10.0.1.2/24, select security zone Management for the tunnel interface, select
the tunnel source interface GigabitEthernet0/1, and enter the VPN domain name vpn1, the
VAM server address 192.168.1.22, the secondary VAM server address 192.168.1.33, the
VAM client username dvpn1hub2, the VAM client password dvpn1hub2, the password
dvpn1hub2 for confirmation, the VAM client pre-shared key 123, and the pre-shared key 123
for confirmation.
c. Select Enable IPsec.
d. Select the IPsec authentication method Pre-Shared Key and then enter abcde in the Key and
Confirm Key fields.
e. Select IP Address as both the remote ID type and the local ID type.
f. Click Apply.
3. Configure tunnel interface Tunnel2 for VPN domain vpn2:
a. From the navigation tree, select VPN > DVPN > Client, and then click Add.