HP VPN Firewall Appliances VPN Configuration Guide

441
Figure 341 Configuring OSPF on tunnel interface
Configuring Hub 2
Hub 2 configuration pages are similar to Hub 1 configuration pages. See the figures for Hub 1
configuration.
1. Configure IP addresses for the interfaces. (Details not shown.)
2. Configure tunnel interface Tunnel1 for VPN domain vpn1:
a. From the navigation tree, select VPN > DVPN > Client, and then click Add.
b. Select the tunnel encapsulation mode UDP. Enter the tunnel interface number 1. Enter the IP
address/mask 10.0.1.2/24. Select security zone Management for the tunnel interface. Select
the tunnel source interface GigabitEthernet0/1. Enter the VPN domain name vpn1. Enter the
VAM server address 192.168.1.22. Enter the secondary VAM server address 192.168.1.33.
Enter the VAM client username dvpn1hub2. Enter the VAM client password dvpn1hub2. Enter
the password dvpn1hub2 for confirmation. Enter the VAM client pre-shared key 123. Enter the
key 123 for confirmation.
c. Select Enable IPsec.
d. Select the IPsec authentication method Pre-Shared Key and then enter abcde in the Key and
Confirm Key fields.
e. Select IP Address as both the remote ID type and the local ID type.
f. Click Apply.
3. Configure OSPF:
a. From the navigation tree, select Network > Routing Management > OSPF.
b. Select Enable OSPF and click Apply.
c. In the Area Configuration area,
click Add.
d. Enter the area
ID 0.
e. Select Normal as the area type.
f. Enter the network address 192.168.1.0, select the network mask 0.0.0.255, and then click
Add Network.