HP VPN Firewall Appliances VPN Configuration Guide

475
[Hub2-Tunnel1] ip address 10.0.1.2 255.255.255.0
[Hub2-Tunnel1] source gigabitethernet 0/1
[Hub2-Tunnel1] ospf network-type p2mp
[Hub2-Tunnel1] ipsec profile vamp
[Hub2-Tunnel1] quit
5. Configure OSPF:
# Configure OSPF for the public network.
[Hub2] ospf 100
[Hub2-ospf-100] area 0
[Hub2-ospf-100-area-0.0.0.0] network 192.168.1.2 0.0.0.255
[Hub2-ospf-100-area-0.0.0.0] quit
# Configure OSPF for the private network.
[Hub2] ospf 200
[Hub2-ospf-200] area 0
[Hub2-ospf-200-area-0.0.0.0] network 10.0.1.2 0.0.0.255
Configuring Spoke 1
1. Configure IP addresses for the interfaces. (Details not shown.)
2. Configure the VAM client:
<Spoke1> system-view
# Create a VAM client named dvpn1spoke1 for VPN 1.
[Spoke1] vam client name dvpn1spoke1
[Spoke1-vam-client-name-dvpn1spoke1] vpn 1
# Specify the IP addresses of the VAM servers and set the pre-shared key.
[Spoke1-vam-client-name-dvpn1spoke1] server primary ip-address 192.168.1.22
[Spoke1-vam-client-name-dvpn1spoke1] server secondary ip-address 192.168.1.33
[Spoke1-vam-client-name-dvpn1spoke1] pre-shared-key simple 123
# Create a local user named dvpn1spoke1, setting the password as dvpn1spoke1.
[Spoke1-vam-client-name-dvpn1spoke1] user dvpn1spoke1 password simple dvpn1spoke1
[Spoke1-vam-client-name-dvpn1spoke1] client enable
[Spoke1-vam-client-name-dvpn1spoke1] quit
3. Configure the IPsec profile:
# Configure the IPsec transform set.
[Spoke1] ipsec transform-set vam
[Spoke1-ipsec-transform-set-vam] encapsulation-mode tunnel
[Spoke1-ipsec-transform-set-vam] transform esp
[Spoke1-ipsec-transform-set-vam] esp encryption-algorithm des
[Spoke1-ipsec-transform-set-vam] esp authentication-algorithm sha1
[Spoke1-ipsec-transform-set-vam] quit
# Configure the IKE peer.
[Spoke1] ike peer vam
[Spoke1-ike-peer-vam] pre-shared-key abcde
[Spoke1-ike-peer-vam] quit
# Configure the IPsec profile.
[Spoke1] ipsec profile vamp
[Spoke1-ipsec-profile-vamp] transform-set vam