HP VPN Firewall Appliances VPN Configuration Guide

476
[Spoke1-ipsec-profile-vamp] ike-peer vam
[Spoke1-ipsec-profile-vamp] sa duration time-based 600
[Spoke1-ipsec-profile-vamp] pfs dh-group2
[Spoke1-ipsec-profile-vamp] quit
4. Configure the DVPN tunnel:
# Configure tunnel interface Tunnel 1 for VPN 1.
To use UDP for tunnel encapsulation, perform the following configurations:
[Spoke1] interface tunnel 1
[Spoke1-Tunnel1] tunnel-protocol dvpn udp
[Spoke1-Tunnel1] vam client dvpn1spoke1
[Spoke1-Tunnel1] ip address 10.0.1.3 255.255.255.0
[Spoke1-Tunnel1] source ethernet 1/1
[Spoke1-Tunnel1] ospf network-type p2mp
[Spoke1-Tunnel1] ospf dr-priority 0
[Spoke1-Tunnel1] ipsec profile vamp
[Spoke1-Tunnel1] quit
To use GRE for tunnel encapsulation, perform the following configurations:
[Spoke1] interface tunnel 1
[Spoke1-Tunnel1] tunnel-protocol dvpn gre
[Spoke1-Tunnel1] vam client dvpn1spoke1
[Spoke1-Tunnel1] ip address 10.0.1.3 255.255.255.0
[Spoke1-Tunnel1] source ethernet 1/1
[Spoke1-Tunnel1] ospf network-type p2mp
[Spoke1-Tunnel1] ospf dr-priority 0
[Spoke1-Tunnel1] ipsec profile vamp
[Spoke1-Tunnel1] quit
5. Configure OSPF:
# Configure OSPF for the public network.
[Spoke1] ospf 100
[Spoke1-ospf-100] area 0
[Spoke1-ospf-100-area-0.0.0.0] network 192.168.1.3 0.0.0.255
[Spoke1-ospf-100-area-0.0.0.0] quit
# Configure OSPF for the private network.
[Spoke1] ospf 200
[Spoke1-ospf-200] area 0
[Spoke1-ospf-200-area-0.0.0.0] network 10.0.1.3 0.0.0.255
[Spoke1-ospf-200-area-0.0.0.0] network 10.0.2.1 0.0.0.255
Configuring Spoke 2
1. Configure IP addresses for the interfaces. (Details not shown.)
2. Configure the VAM client:
<Spoke2> system-view
# Create a VAM client named dvpn1spoke2 for VPN 1.
[Spoke2] vam client name dvpn1spoke2
[Spoke2-vam-client-name-dvpn1spoke2] vpn 1
# Specify the IP addresses of the VAM servers and set the pre-shared key.