HP VPN Firewall Appliances VPN Configuration Guide

[FirewallB] interface tunnel 0

[FirewallB-Tunnel0] ipv6 address 3001::2/64

[FirewallB-Tunnel0] source gigabitethernet 0/2

[FirewallB-Tunnel0] destination 192.168.100.1

[FirewallB-Tunnel0] tunnel-protocol ipv6-ipv4

[FirewallB-Tunnel0] quit

# Configure a static route to IPv6 Group 1 through Tunnel 0 on Firewall B.

[FirewallB] ipv6 route-static 3002:: 64 tunnel 0

Verifying the configuration

# Display the status of the tunnel interfaces on Firewall A and Firewall B.

[FirewallA] display ipv6 interface tunnel 0

Tunnel0 current state :UP

Line protocol current state :UP

IPv6 is enabled, link-local address is FE80::C0A8:6401

Global unicast address(es):

3001::1, subnet is 3001::/64

Joined group address(es):

FF02::1:FF00:0

FF02::1:FF00:1

FF02::1:FFA8:6401

FF02::2

FF02::1

MTU is 1480 bytes

ND reachable time is 30000 milliseconds

ND retransmit interval is 1000 milliseconds

Hosts use stateless autoconfig for addresses

IPv6 Packet statistics:

InReceives: 55

...

[FirewallB] display ipv6 interface tunnel 0