HP VPN Firewall Module Series - HP SECBLADEIII-CMW520-R3819P01 Release Notes

5
 Condition: This symptom occurs if the CRL acquisition operation is performed when the
memory usage exceeds 95% because of large amounts of TCP and UDP traffic.
201309100016
 Symptom: The SecBlade card unexpectedly reboots when multiple voice NQA
operations that have the same source but different destinations are configured.
 Condition: This symptom occurs when multiple voice NQA operations that have the
same source but different destinations are configured.
201309040150
 Symptom: An inter-zone policy can never be matched.
 Condition: This symptom occurs if the following conditions exist:
 There are two inter-zone policies that have the same information except for their
bound content filtering policies.
 The inter-zone policy that can never be matched has a lower match priority.
Resolved problems in R3817
201304220334
 Symptom: Memory leaks occur after the SecBlade card has received large numbers of
fragment packets in an asymmetric stateful failover scenario.
 Condition: This symptom occurs after the SecBlade card has received large numbers
of fragment packets in an asymmetric stateful failover scenario.
201307170414
 Symptom: The nat traversal field in IKE SA entries displays "No" when IPsec NAT traversal
has been enabled.
 Condition: This symptom can be seen after IPsec tunnels have been established in an
IPsec NAT traversal scenario.
201304020407
 Symptom: A SecBlade card might reboot when you execute a display command.
 Condition: This symptom might occur when the following conditions exist:
 The configuration file of the SecBlade card exceeds 100 KB.
 The display command includes a regular expression, for example, the display
current-configuration | include .*.*.*/." command.
201306190471
 Symptom: After traffic matches NAT444 rules on an interface, the SecBlade card does
not create NAT444 entries for the traffic.
 Condition: This symptom might occur if the interface has two NAT444 rules that each
reference an ACL. The two ACLs specify a common source IP address but different
destination IP addresses.
HSD113119
 Symptom: If you export the configuration file through configuration backup and then
import the configuration file through configuration import, the firewall prompts that
some configurations are failed to be imported.