HP VPN Firewall Module Series - HP SECBLADEIII-CMW520-R3819P05 Release Notes

|<5> Modify Serial Interface Parameter |

|<0> Exit To Main Menu |

============================================================================

Enter your choice(0-5):

14. Enter 1 in the EXTEND-BOOTWARE menu to boot the system.

15. If you are using a download rate other than 9600 bps, change the baud rate of the

terminal to 9600 bps. If the baud rate has been set to 9600 bps, skip this step.

Upgrading the BootWare

You can upgrade the BootWare from the CLI or BootWare menus.

Upgrading the BootWare from the CLI

Whether a .btw file is compressed together with a .bin file depends on the software release.

Please check it with HP technical support. This section describes only how to upgrade the

BootWare from the CLI.

To upgrade the BootWare from the CLI:

1. Use FTP or TFTP to download or upload the new BootWare image file to the root

directory of the storage medium on the firewall module.

2. Use the bootrom upgrade command to upgrade the BootWare.

<System> bootrom update file cfa0:/main.btw

This command will update bootrom file, Continue? [Y/N]:y

Now updating bootrom, please wait...

Updating basic bootrom!

Update basic bootrom success!

Updating extended bootrom!

Update extended bootrom success!

Update bootrom success!

3. Use the reboot command to reboot the firewall module.

Upgrading the BootWare from BootWare menus

This BootWare upgrade method is available only if password recovery capability is

enabled.

Accessing the EXTEND-BOOTWARE menu

See "Accessing the EXTEND-BOOTWARE menu."

Using TFTP/FTP to upgrade the BootWare through an Ethernet port

1. Enter 7 in the BootWare menu to access the BootWare operation submenu.

=========================<BootWare Operation Menu>==========================

|Note:the operating device is cfa0 |

|<1> Backup Full BootWare |