HP VPN Firewall Module Series - HP SECBLADEIII-CMW520-R3819P05 Release Notes

201306190471

 Symptom: After traffic matches NAT444 rules on an interface, the SecBlade card does

not create NAT444 entries for the traffic.

 Condition: This symptom might occur if the interface has two NAT444 rules that each

reference an ACL. The two ACLs specify a common source IP address but different

destination IP addresses.

HSD113119

 Symptom: If you export the configuration file through configuration backup and then

import the configuration file through configuration import, the firewall prompts that

some configurations are failed to be imported.

 Condition: This symptom occurs if you export the configuration file through

configuration backup and then import the configuration file through configuration

import.

HSD113967

 Symptom: Memory leaks occur when DNS flooding attack protection is discarding

packets, resulting in forwarding failure.

 Condition: This symptom can be seen when the following conditions exist:

 DNS flooding attack protection is discarding packets.

 The firewall receives a non-SYN TCP packet that does not carry ACK.

HSD113532

 Symptom: A firewall unexpectedly reboots upon receiving abnormal ICMP messages

from EasyHacker.

 Condition: This symptom occurs when a firewall receives abnormal ICMP messages

from EasyHacker.

HSD113882

 Symptom: A firewall enabled with GTP ALG unexpectedly reboots after a long-time

operation.

 Condition: This symptom can be seen if the following conditions exist:

 GTP ALG is enabled.

 The firewall has run for a long time.

Resolved problems in R3816

First release.