InMon Traffic Sentinel Installation and Getting Started Guide 2009-01

 9
ProCurve# services <CR>
Installed Services
Slot Index Description Name
B 1. Services Module services-module
B 2. InMon Traffic Sentinel sentinel
The Traffic Sentinel service is now activated in Slot B at index 2 and has the name
Traffic Sentinel. Type either of the following commands to access the Traffic Sentinel
CLI:
ProCurve# services b 2 <CR>
ProCurve(sentinel-B)#
Or
ProCurve# services b name sentinel <CR>
ProCurve(sentinel-B)#
6. Configure the Services zl Module ports into a specific VLAN
The Services zl Module provides two internal Ethernet port connections into the switch
after installation. By default, both ports are placed in the default VLAN. For example, if
the Services zl Module is installed into slot B of the switch chassis, the internal ports
appear as B1 and B2, and are automatically placed in the default VLAN. Depending on
the VLAN configuration in the switch, one or both of these ports may need to be
reassigned into a different VLAN. This is done by using the switch's management
interface, just like any other port on the switch. The VLAN that the internal ports are
placed in is important when configuring network parameters (e.g. IP address) for the
services on the zl Module. These network parameters need to match the network
configuration of the VLAN they are members of.