Installation and Getting Started Guide for 745wl and ACM xl 2006-06

ProCurve Secure Access 700wl Series Installation and Getting Started Guide 3-11
Network Setup
Figure 3-8. Local Networks Page
Step 6.
If appropriate, enter a fully-qualified hostname for this Access Control Server.
Step 7. Enter the name of the domain in which this Access Control Server resides.
Step 8. To use DHCP to obtain an IP address for this unit, select Using DHCP from the Configure drop-
down list.
When
Configure is set to Using DHCP, you cannot change the IP Address, Subnet Mask, or
Gateway. You can change the DNS and WINS server IP addresses, if necessary.
If your DHCP server is configured appropriately, the IP address, subnet mask (netmask),
gateway, and primary and secondary DNS addresses will already be filled in.
Step 9. To set a static IP address, select Manually from the Configure drop-down list, then type the IP
Address and other values, as appropriate, in the fields on this page.
Step 10. Click Save.