Installation and Getting Started Guide for 745wl and ACM xl 2006-06

ProCurve Secure Access 700wl Series Installation and Getting Started Guide 3-13
Network Setup
Step 16.
If you want to allow remote access to the CLI on this unit via a remote SSH client, leave the check
in the
Enable SSH command line interface box (this is the default). To disable remote access,
uncheck the box.
Enable technical support access only if requested to do so by an authorized ProCurve support
engineer.
Step 17. Click Save.
Note: You must enter and confirm a shared secret—the 700wl Series system does not let you
save this configuration without one.
Step 18. To set the system date and time, and time zone if necessary, click the Date & Time tab. The Date &
Time page appears (see Figure 3-10).
Figure 3-10. Date & Time Page
Step 19.
To set the time zone, select the appropriate setting from the Time Zone drop-down list.
Step 20. To configure an NTP server, click the Set time using network time server check box, and type the
IP address of a primary and (optionally) a secondary NTP server.
Step 21. Click Save.
Step 22. To set the date and time immediately, select the appropriate values and click Set Time Now.