Installation and Getting Started Guide for 745wl and ACM xl 2006-06

3-18 ProCurve Secure Access 700wl Series Installation and Getting Started Guide
Network Setup
Figure 3-13. Local Networks Page
c.
From the System Components List in the left panel under the Local Networks heading, select
the Access Controller Module you just installed. The
Basic Setup page is displayed.
d. Verify that the information for the Access Controller Module is correct, or enter additional
settings as necessary. From the
Advanced Setup sub-tab you can configure Bridging, IP
broadcast forwarding, and client polling; from the
SSL sub-tab you can configure the address
of a proxy server for HTTP requests.
e. Click Save to save any changes you have made to any of the sub-tabs on this page.
Step 4. Complete the installation by connecting one or more wireless access points to the Access
Controller Module ports on the 5300xl switch, using standard (either crossover or straight-
through) 10Base-T/100Base-TX Ethernet cables.
See the ProCurve Secure Access 700wl Series Management and Configuration Guide for detailed information on
the features of the Administrative Console.