Installation and Getting Started Guide for 745wl and ACM xl 2006-06

ProCurve Secure Access 700wl Series Installation and Getting Started Guide 4-5
Basic Configuration
Figure 4-2. Enabling PPTP for the 700wl Series system
Step 3. Under Encryption Protocols, put a check mark in the Enable PPTP check box, then click Save.
Configuring Access Policies for Encryption
The next step is to configure the appropriate Access Policies to allow the use of encryption. You must
allow encryption for the “Unauthenticated” Access Policy so that an unknown client using encryption
can connect to the 700wl Series system, and you must enable encryption for the relevant Access Policy
that will take effect once the client has been successfully authenticated—in this case, the “Authenticated”
Access Policy.
Step 1. From the Navigation toolbar, click the RIGHTS button to go to the Rights Manager.
Step 2. Click the Access Policies tab to go to the Access Policies page, as shown in Figure 4-3.