Installation and Getting Started Guide for 745wl and ACM xl 2006-06

4-12 ProCurve Secure Access 700wl Series Installation and Getting Started Guide
Basic Configuration
Note: Your RADIUS server must be configured to recognize the Access Control Server as a RADIUS
client.
To configure the Rights Manager to use a RADIUS server for authentication, do the following:
Step 1. From your management station, point your browser to the IP address or hostname of your Access
Control Server, and logon to the Administrative Console.
The initial page of the Administrative Console appears.
Step 2. Click the RIGHTS button to go to the Rights Manager.
Step 3. Click Authentication Policies tab to go to the Authentication Policies page (Figure 4-11).
Figure 4-11. Authentication Policies Page
Step 4.
Click the Authentication Services link in the left panel.
The Authentication Services page appears.
Step 5. Click New.
The New Authentication Service—LDAP page appears.
Step 6. Click the RADIUS link to display the New Authentication Service—RADIUS page (Figure 4-12).