Installation and Getting Started Guide, ONE Advanced Services zl Module 2010-03

2-3
Getting Started
Initial Configuration
Initial Configuration
The Command Line Interface (CLI) must be used to carry out the steps
required to configure the module.
The module CLI is accessed through the switch CLI, and is available in the
Service OS (full command set) and ONE-app (limited command set).
Updating Switch Software
Before configuring the module, access the switch CLI to verify the switch has
the most current module-compatible software installed. Use the following
command to check the software version:
hostswitch# show version
Image stamp: ...
<
date, time >
K.14.XX
...
Boot Image: Secondary
If a software update is needed, follow the instructions on page D-1 in the Web
version of this document at www.hp.com/go/procurve/manuals.
When the switch has the correct software version installed, use the following
CLI command to check if the module is installed:
hostswitch# show modules
The above command shows all the modules installed in the switch, and their
slot numbers.
Use the following command to see all Field Replaceable Units (FRUs)
installed on the module:
hostswitch# show modules details
To get more detailed information about the Service Module status and any
installed application use the following command for a module in slot ‘C’:
hostswitch# show services c details