Manualshelf

Installation and Getting Started Guide, ONE Advanced Services zl Module 2010-03

ManualsBrandsHP ManualsComputer AccessoriesHP ProCurve Switch xl Access Controller Module
11121314151617181920
2-4
Getting Started
Initial Configuration
An example output from this command looks as follows:
Updating Module Software
The module maintains a repository of the software images that are down-
loaded to it. The installation of software depends on the image type. There are
two image types:
■ Service image
■ ONE-app image
The Service and ONE-app images are containers for full OS installations, and
are referred to as OS images. These images are generally large in size, typically
greater than 200MB. The OS images don't change frequently and are usually
only used for recovery or major version updates or to fix major OS problems.
There are two installation commands:
■ Install
■ Update
The install command is used for new installations of the primary and backup
OS image. Before a new OS can be installed, the existing OS must be removed
by using the uninstall command. In addition, the ONE-app must also be
uninstalled.
The update command is used to modify an existing installation of the primary
and backup OS. The update is done “in-place” without requiring an uninstall
of the OS. The partition sizes of the new and current OS must match, otherwise
the update command will display an error and abort the process. Updating an
existing Service OS does not require the ONE-app to be removed first.