Installation and Getting Started Guide, ONE Advanced Services zl Module 2010-03

2-5
Getting Started
Initial Configuration
Service OS Installation
Periodically, Service OS updates are available from HP ProCurve. To check
the Service OS version installed on the module, first boot the Service OS, if it
is not already booted. Then, access the module’s Service OS CLI:
hostswitch# services c 1
Then, use the following CLI command:
hostswitch(svcs-mod-C:SvcOS)# show version
This command will show the version number for the Service OS. It will also
show the version number of the installed ONE-app (if any). Here is an example
output from this command:
If an install/update to the Service OS is needed, follow the instructions on page
D-2 in the Web version of this document at www.hp.com/go/procurve/manuals.
Running: ServiceOS
Loaded from: Primary Flash
Installed images:
-------- ONE-app ---------------------------------
Not installed
-------- ServiceOS -------------------------------
J9999A ONE ServiceOS version 1.0.090915
Description: ServiceOS Rev B
Build Date: Sep 15 2009 22:09
Installed at: Primary Flash
-------- Backup ServiceOS ------------------------
J9999A ONE ServiceOS version 1.0.090915
Description: ServiceOS Rev B
Build Date: Sep 15 2009 22:09
Installed at: Backup Flash