Installation and Getting Started Guide, ONE Advanced Services zl Module 2010-03

C-7
Hardware Components
Replacing the Disk Drive
7. Install the new disk drive and slide it forward to engage the connector.
8. Re-install the four retaining screws.
9. If applicable, remove the cover from the slot where the module will be
re-installed. Re-install the module into the switch.
10. Use an equal amount of pressure and push both extractor handles closed
to completely seat the module.
11. Tighten the retaining screws.
Figure C-5. Steps to Replacing the Module’s Disk Drive
1. 2.
3. 4.
Retaining Screws
Extractor Handles
Retaining Screws
Disconnected