Installation and Getting Started Guide, ONE Advanced Services zl Module 2010-03

C-8

Hardware Components

Replacing the Compact Flash

The following is the procedure for replacing the compact flash in the module.

The module may be removed while the switch is powered on. The numbers in

Figure C-6 correspond to the step numbers below.

1. Using either a flat-bladed or Torx T-10 screwdriver loosen the retaining

screws securing the module.

2. Using the extractor handles, pull the module out from the slot and turn

it over. In the meantime, if the chassis is still operational, use a slot cover

to cover this slot, to ensure proper cooling.

3. Slide out the old compact flash by applying slight pressure to the top of

the compact flash.

4. Position the new compact flash properly and slide it in being careful not

to bend any connector pins.

5. If applicable, remove the cover from the slot where the module will be

re-installed. Re-install the module into the switch.

6. Use an equal amount of pressure and push both extractor handles closed

to completely seat the module.

7. Tighten the retaining screws.

1. 2.

Retaining Screws

Extractor Handles