Management and Configuration Guide (Includes ACM xl) 2005-12

4-72 ProCurve Secure Access 700wl Series Management and Configuration Guide
Configuring Rights
Figure 4-35. Creating a New Redirected Traffic Filter
You can create the filter specification in one of two ways:
• Specify the traffic protocol, and the destination IP address and port, or
• Define the filter as a regular expression in tcpdump syntax. This enables you to define complex
filters.
You specify the new destination by providing a port and IP address that the traffic should be redirected
to.
To create or edit a Redirected Traffic filter, do the following:
Step 1. Type a name for this filter. You can change the name of an existing Allowed Traffic filter by
typing a new name.
Step 2. Type a description for the filter, or modify the existing description.
Step 3. To specify the filter by selecting the protocol, and providing the port and destination IP
address, select the
Capture traffic via a specific protocol/port/address radio button. Then do the
following:
a. Select the protocol of the traffic you want to allow from the drop-down list in the Protocol
field.
b. If the protocol requires a destination port, type it into the Port field. If the protocol does not
support port specifications,
N/A appears in the port field. You can enter a single port, or use
an asterisk (*) to specify all ports.
You can access a list of ports by clicking the View button ( ) at the right of the
Port field.