Management and Configuration Guide (Includes ACM xl) 2005-12

6-8 ProCurve Secure Access 700wl Series Management and Configuration Guide
Configuring the Network
Editing the Integrated Access Manager Configuration
The Integrated Access Manager is typically configured with its network configuration parameters and
shared secret when it is initially installed on the network, per the instructions in the Quick Start Guide or
Installation and Getting Started Guide shipped with the hardware.
However, there is one situation in which you may need to modify the Integrated Access Manager
configuration:
• To enable SSH access to the unit for remote CLI or Technical Support access
» To edit a Integrated Access Manager configuration, click on the name of the Integrated Access Manager
in the System Components List, or click the pencil icon ( ) to the far right of the Integrated Access
Manager.
The Edit Integrated Access Manager page appears as shown in Figure 6-4.
Figure 6-4. Edit Integrated Access Manager Page
The fields on the Edit Integrated Access Manager page show the current setting for the Integrated
Access Manager. You can modify any of these values, except the IP address and System ID, which are
read-only fields.
Note:
The IP address can be changed under the Network Setup tab, along with other network
configuration settings.