Management and Configuration Guide (Includes ACM xl) 2005-12

ProCurve Secure Access 700wl Series Management and Configuration Guide 6-9
Configuring the Network
The fields and options on this page are defined in Table 6-3:
» To modify the Integrated Access Manager settings, edit the desired fields and click Save.
To abandon your changes and revert to the current settings click
Cancel.
Table 6-3. Edit Integrated Access Manager Page Fields
Field/Option Description
Name An alphanumeric name for this Integrated Access Manager. The
default name is the IP address of the unit.
Names can be up to 50 characters in length.
IP Address The IP address of this Integrated Access Manager (read-only). This
can be changed under the Network Setup tab.
System ID The System ID is the MAC address of the reserved port on a 700wl
Series unit. On a 700wl Series unit, the System ID is the MAC
address of the uplink port.
NAS-ID/Description A description for this unit. If using RADIUS accounting, this field is
used as the NAS-ID and is sent to the RADIUS server as part of the
accounting information. (If you do not enter a NAS-ID, the MAC
address of the Integrated Access Manager is sent instead.) See
“Using RADIUS for Accounting” on page 5-29 for more details about
the RADIUS accounting feature.
Shared Secret The shared secret used to establish a trust relationship between the
Integrated Access Manager and (the shared secret does not affect
the internal Access Controller).
Confirm Shared Secret The shared secret, entered a second time to confirm.
Admin Username The username for the built-in administrator of this Integrated Access
Manager. The default is admin. The name can be up to 50
characters. The built-in administrator logon cannot be deleted.
Admin Password The password for the built-in administrator of this Integrated Access
Manager. The default is admin. The password must be at least one
(non-blank) character in length (a minimum of 5 is recommended).
Confirm Admin Password The administrator password, entered a second time to confirm.
Enable ProCurve technical support access (Optional.) A mark in this check box enables access by the Technical
Support personnel at ProCurve to this Access Control Server.
Note: Enable this feature only if directed to do so by your Technical
Support contact.
Enable SSH command line interface (Optional.) A mark in this check box enables remote access to the
Command Line Interface for this Integrated Access Manager via
SSH. This requires that the client system running the CLI supports
SSH.
If this check box is not checked, remote access to the CLI is
disabled. The CLI can be accessed only over a direct connection to
the serial port on the Integrated Access Manager.