Management and Configuration Guide (Includes ACM xl) 2005-12

6-10 ProCurve Secure Access 700wl Series Management and Configuration Guide
Configuring the Network
Configuring Access Controllers
An Access Controller that has been installed on the network and configured to communicate with the
Access Control Server (with the Access Control Server’s IP address and shared secret) appears
automatically in the System Components List.
With the exception of the Access Control Server IP address and shared secret, Access Controllers are
configured centrally from the of the Access Control Server or Integrated Access Manager. From the
Administrative Interface you can configure and delete Access Controllers, as well as organize them into
folders.
Note:
Once the Access Control Server has recognized and is managing an Access Controller, you should
not attempt to configure the Access Controller directly through the CLI, as doing so may conflict with the
settings maintained for the Access Controller by the Access Control Server.
» To edit an Access Controller’s settings, click the name of the Access Controller in the System
Components List, or click the pencil icon ( ) to the far right. If the Access Controller is in a folder that
is closed, you will need to open the folder before you can select the Access Controller.
The Edit Access Controller page appears. See Figure 6-5.
Figure 6-5. Edit Access Controller Page