Management and Configuration Guide (Includes ACM xl) 2005-12

ProCurve Secure Access 700wl Series Management and Configuration Guide 6-11
Configuring the Network
The fields on the Edit Access Controller page show the current setting for the Access Controller. This
includes the following information:
Table 6-4. Edit Access Controller Page Fields
Field/check box Description
Name An alphanumeric name for the Access Controller. By default the
name is the IP address of the unit.
IP Address The IP address of this Access Controller (read-only). This can be
changed under the Local Network tab.
System ID The System ID is the MAC address of the reserved port on a 700wl
Series unit. On a 700wl Series unit, the System ID is the MAC
address of the uplink port.
NAS-ID/Description A description for this Access Controller. If using RADIUS accounting,
this is used as the NAS-ID and is sent to the RADIUS server as part
of the accounting information. (If you do not enter a NAS-ID, the
MAC address of the Access Controller is sent instead.) See “Using
RADIUS for Accounting” on page 5-29 for more details about the
RADIUS accounting feature.
Admin Username The built-in administrator username for this Access Controller. The
default is admin. The name can be up to 50 characters. The built-in
administrator logon cannot be deleted.
Admin Password The built-in administrator password for this Access Controller. The
default is admin. The password must be at least one (non-blank)
character in length (a minimum of 5 is recommended).
Confirm Admin Password The administrator password, entered a second time to confirm.
Folder (Optional.) The name of the folder in which to place this Access
Controller.
Pull down the list to select a folder. By default the Access Controller
is placed in the Default folder.
See “Folders vs. Locations” on page 6-13 for more information on
Folders.
Enable HP technical support access (Optional.) A check in this check box enables access by the
Technical Support personnel at ProCurve to this Access Controller.
Note: Enable this feature only if directed to do so by your ProCurve
Technical Support contact.
Enable SSH command line interface (Optional.) A check in this check box enables remote access to the
Command Line Interface for this Access Controller via SSH. This
requires that the client system running the CLI supports SSH.
If this check box is not checked, remote access to the CLI is
disabled. The CLI can be accessed only over a direct connection to
the serial port on the Access Controller.
Access Control Server
Access Control Server IP The IP address of the Access Control Server to which this Access
Controller should be connected.
Shared Secret The shared secret used to validate this Access Controller to its
Access Control Server. It must match exactly the shared secret
configured on the Access Control Server.