Management and Configuration Guide (Includes ACM xl) 2005-12

ProCurve Secure Access 700wl Series Management and Configuration Guide 6-25
Configuring the Network
c.
If you selected -Auto-, you can elect to Use DHCP to get the IP address information, or you
can enter the starting IP address, and gateway address, and select the appropriate subnet
mask.
d. To allow the device to be managed from upstream via this local network (for administrator
and technical support access if it is enabled for the system) select
Allow Mgmt.
Step 4. To delete a local subnet, click the trashcan at the end of the row. The subnet will not be deleted
until you
Save.
Step 5. Click Save to save your settings.
To restore these fields to the original default settings, click
Reset to Defaults. You must then Save
to actually have the defaults take effect.
To abandon your changes and revert to the current settings, click
Cancel.
Note:
Save saves all changes made on any of the sub-tabs since the last Save. Cancel discards
all changes on all sub-tabs since the last save.
Adding a Subnet using the -Auto- configuration setting usually causes a new subnet and Subnet Group
to be created under the Global Network page. The Local Network page will continue to show the
-Auto-
selection for the subnet until you leave the Local Network page. When you return, the new subnet will
appear in the Subnet field.
The Advanced Setup Tab
Step 1. From the Local Networks tab, click the Advanced Setup tab.
The Advanced Setup page appears. Figure 6-13 show the Advanced Tab for an Integrated Access
Manager, which includes all the settings for both an Access Control Server and an Access
Controller.