Management and Configuration Guide (Includes ACM xl) 2005-12

ProCurve Secure Access 700wl Series Management and Configuration Guide 6-39
Configuring the Network
Figure 6-21. Interfaces: Speed/Duplex Page
Step 3. Select the connection type from the list provided in the drop-down list.
Note:
If you want to set a port to half-duplex, but half-duplex is not offered as an option in the
drop-down list, you will need to select a setting that does not specify an option, and allow the
port to negotiate for half-duplex. For example, as shown in Figure 6-21, there is no setting for
100baseTX half-duplex. You must specify 100baseTX and allow the port to negotiate for half-
duplex.
Step 4.
Click Save.
To restore the settings to the predefined default settings, click
Reset to Defaults
To abandon your changes and revert to the current settings click Cancel.
Note:
The port configuration process takes several seconds to take effect. When you initially return to
the Speed/Duplex tab, the connection type shown in parentheses may reflect the previously configured
type. You may need to refresh the page to update the display for the new type.
Configuring SNMP
Simple Network Management Protocol (SNMP) is a standard for network management. SNMP enables
network administrators to remotely manage the equipment on their networks.
The 700wl Series system SNMP module enables 700wl Series system components to be monitored via
SNMP from a network management application such as HP OpenView or Aprisma SPECTRUM.