Management and Configuration Guide (Includes ACM xl) 2005-12

6-40 ProCurve Secure Access 700wl Series Management and Configuration Guide
Configuring the Network
Note: The 700wl Series system supports Management Information Base-2-compliant objects. The four
ProCurve MIBS are available from the Software and Downloads section of the ProCurve support web site
at www.hp.com.
To configure SNMP for the 700wl Series system:
Step 1. Click the SNMP tab from any page in the network configuration module.
The SNMP page is displayed, as shown in Figure 6-22.
Figure 6-22. SNMP Page
Step 2. Select the system component for which you want to enable SNMP from the System
Components List.
Step 3. SNMP is disabled by default. Select Enabled from the SNMP drop-down menu to enable SNMP.
This will enable SNMP for the selected component.
Note:
Enabling SNMP allows Read-only access to the device as indicated by the value in the
SNMP Access Mode field.
Step 4. Type the appropriate read Community Name.
The default name is
public; you should change it to match the read community name configured
for your SNMP manager.
Step 5. Type the port number of your SNMP Port.
Port 161 is the default. If you change the port number, be careful that you do not use a port that is
used by another application.