Management and Configuration Guide (Includes ACM xl) 2005-12

ProCurve Secure Access 700wl Series Management and Configuration Guide 8-17
System Maintenance
Figure 8-11. Restart Confirmation
Step 3. To proceed with the reboot, click Continue.
To cancel the reboot, click
Cancel.
Shutting Down a System Component
Shutting down a system component shuts down and powers off the selected unit.
To shut down and power off a system component:
Step 1. Select the unit you want to shut down from the System Components List.
Step 2. Click Shutdown Now.
A confirmation page appears.
Step 3. To proceed with the shutdown, click Continue.
To cancel the shutdown, click
Cancel.
Resetting to Factory Default Settings
Resetting a system to its factory defaults will clear the configuration database, reset all options to the
factory default settings, and reboot the unit.
Warning:
If you have reconfigured the uplink on this component to use a port other than the default
uplink port (such as the gigabit fiber port on an option card) you are strongly advised to remove the unit
from the network and do the reset operation using the serial console and CLI.
A factory reset operation resets the uplink to the default uplink port, and your reconfigured uplink port
reverts to a downlink port. This can have adverse effects on your network. You must use the serial
console interface and CLI to reconfigure the uplink port.
To reset a selected system component to use the factory default configuration settings:
Step 1. Select the unit you want to reset from the System Components List.
Step 2. Click Reset Now.
A confirmation page appears, as shown in Figure 8-12.