Management and Configuration Guide (Includes ACM xl) 2005-12

ProCurve Secure Access 700wl Series Management and Configuration Guide A-7
show id
Displays this system’s ID, which is the MAC address of Slot 0 port 1.
On a 700wl Series system, slot 0 port 1 is the default uplink port. The MAC address of the default
uplink port is also shown on the serial number label on the back of the unit.
On a 700wl Series unit, the MAC address used as the system ID by the software is also port 0 slot 1.
(Slot 0 port 1 is the Reserved port.) Therefore, the MAC address of the uplink port, shown on the
label on the back of the unit, will be one higher than the MAC address used as the system ID.
For example, if the label on the back of your unit showed 00:E0:18:50:1D:AC as the MAC address
(for the uplink, slot 0 port 2) then the
show id command would display 00:E0:18:50:1D:AB as the
system ID. This ID is also displayed when you first logon through the serial console.
show ether [status]
Displays the configuration and status of the interface(s) in the system. The port currently
configured as the uplink port has Uplink appended to the end of the status entry for that interface.
The default form of the command (
show ether) displays the MAC Address, interface name, and
supported media types (in parentheses) of each interface, as shown in the following example:
System Board: 1 Ethernet port
0/1: 00:e0:18:7d:b5:3d, sis0, (100baseTX, 10baseT/UTP), Uplink
Slot 3: 4 Ethernet ports
3/1: 00:80:c8:b9:21:60, dc3, (100baseTX, 10baseT/UTP)
3/2: 00:80:c8:b9:21:5f, dc2, (100baseTX, 10baseT/UTP)
3/3: 00:80:c8:b9:21:5e, dc1, (100baseTX, 10baseT/UTP)
3/4: 00:80:c8:b9:21:5d, dc0, (100baseTX, 10baseT/UTP)
The show ether status command displays the MAC Address, the currently configured media
type/option, the active media type/option (in parentheses) and the link status, as shown in the
following example:
System Board: 1 Ethernet port
0/1: 00:e0:18:7d:b5:3d, autoselect (100baseTX <full-duplex>), active
Slot 3: 4 Ethernet ports
3/1: 00:80:c8:b9:21:60, autoselect (none), no carrier
3/2: 00:80:c8:b9:21:5f, autoselect (none), no carrier
3/3: 00:80:c8:b9:21:5e, autoselect (none), no carrier
3/4: 00:80:c8:b9:21:5d, autoselect (none), no carrier
show slots
Shows the card in each slot. The output for an Integrated Access Manager 760wl or Access
Controller 720wl with two of the three slots filled appears as follows:
Slots: 3
System Board: 2 Ethernet ports
Slot 1: Empty
Slot 2: 4 Ethernet ports
Slot 3: 4 Ethernet ports
show deviceport <device>
Shows the port or slot and port for a device.