Management and Configuration Guide (Includes ACM xl) 2005-12

A-8 ProCurve Secure Access 700wl Series Management and Configuration Guide
For example, on an Integrated Access Manager 760wl the command:
show deviceport sis0
displays the following output:
Slot/Port: 0/1
show product
Displays the product name. For example, on an Integrated Access Manager 760wl, this command
displays:
Integrated Access Manager
show serial
Displays the product serial number. The output is similar to the following:
10-00E0187DB53D
show version
Displays the current software version. Also shows the alternate (upgrade, downgrade or same)
version of the software, if one exists on the system. The output is similar to the following:
Version Build Date Install Date
------- -------------------- --------------------
Active: 3.1.43 Feb 24 18:21:49 2003 Feb 25 12:37:25 2003
Alt: 3.0.36 Feb 7 01:22:18 2003 Feb 11 19:45:55 2003 downgrade
refresh client all | [mac <mac-address>]
Note: This command is supported on the Access Control Server or Integrated Access Manager only.
Refreshes the rights for a specific client, identified by MAC address, or for all clients. The command
refresh client all refreshes the rights of all the clients on the 700wl Series system.
Network Configuration Commands
set hostname <hostname>
Note: This command is supported on the Access Control Server or Integrated Access Manager only.
Sets the system's hostname. The system hostname is also used as the SNMP system name. If you set
a hostname, it must be resolvable through DNS.
<device> The device name associated with a port, for example, dc0, dc1, sis0
<hostname> The fully qualified host name of the system.