Management and Configuration Guide (Includes ACM xl) 2005-12

A-10 ProCurve Secure Access 700wl Series Management and Configuration Guide
clear gateway
Clears the gateway IP address (resets to 0.0.0.0). This is the equivalent of the command set gateway
0.0.0.0
.
set dhcp on | off
Enables dynamically-assigned IP address configuration for this system. If disabled the system's IP
address, subnet (netmask), gateway, and DNS servers must be set manually. The default (at factory
reset) is ON.
set dhcpserver <ip-address>
Note: This command is supported on the Access Control Server or Integrated Access Manager only.
Sets the IP address to be used as a DHCP server for clients connected to an Access Controller that
does not use NAT.
clear dhcpserver
Note: This command is supported on the Access Control Server or Integrated Access Manager only.
For an Access Controller, this function must be performed through the Administrative Interface on the
managing Access Control Server.
Resets the currently configured DHCP server value.
show dhcpserver
Shows the currently configured DHCP server value, or “Not Set” if no DHCP server is configured.
set dns <primary-ip-address> [<secondary-ip-address>]
Note: This command is supported on the Access Control Server or Integrated Access Manager only.
For an Access Controller, this function must be performed through the Administrative Interface on the
managing Access Control Server.
Sets the IP addresses of the DNS servers.
clear dns
Note: This command is supported on the Access Control Server or Integrated Access Manager only.
For an Access Controller, this function must be performed through the Administrative Interface on the
managing Access Control Server.
Clears the IP addresses of the DNS servers.
<ip-address> The DHCP server IP address.
<primary-ip-address> The IP address of the primary DNS server for the system.
<secondary-ip-address> The IP address of the secondary DNS server for the system (optional).