Management and Configuration Guide (Includes ACM xl) 2005-12

ProCurve Secure Access 700wl Series Management and Configuration Guide A-11
set sharedsecret [<secret> <secret> ]
Sets the shared secret used to validate a connection between an Access Controller and Access
Control Server. Prompts for the secret if not entered on the command line.
Note:
Once a connection has been established between an Access Controller and its Access Control
Server (or Integrated Access Manager), changing the shared secret on either unit does not disrupt
this communication. To disconnect an Access Controller from a Access Control Server, you must both
change the shared secret and change the Access Control Server IP address configured in the Access
Controller.
clear sharedsecret
Clears the shared secret.
show sharedsecret
Shows whether the shared secret is set. The shared secret itself is not displayed. Output from this
command is as follows:
Shared secret: Set
or
Shared secret: Not Set
set wins <primary-ip-address> [<secondary-ip-address>]
Note: This command is supported on the Access Control Server or Integrated Access Manager only.
For an Access Controller, this function must be performed through the Administrative Interface on
the managing Access Control Server.
Sets the IP addresses of the WINS servers.
clear wins
Note: This command is supported on the Access Control Server or Integrated Access Manager only.
For an Access Controller, this function must be performed through the Administrative Interface on
the managing Access Control Server.
Clears the IP addresses of the WINS servers.
Port Configuration Commands
The first set of commands in this section can be used on both an Access Controller or Access Control
Server. The Access Controller-specific port commands apply only to downlink ports on an Access
Controller or Integrated Access Manager.
<primary-ip-address> The IP address of the primary WINS server for the system.
<secondary-ip-address> The IP address of the secondary WINS server for the system (optional).