Management and Configuration Guide (Includes ACM xl) 2005-12

ProCurve Secure Access 700wl Series Management and Configuration Guide A-13
displays output similar to the following:
Port 3/1 media settings
Port status: active
Configured setting: autoselect
Active port setting: 100baseTX full-duplex
Supported settings: autoselect
100baseTX full-duplex
100baseTX
10baseT/UTP full-duplex
10baseT/UTP
none
Port status
can be active or no carrier.
Configured setting is the current setting as configured through the set portmedia command (or
through the Advanced Network Settings page of the Administrative Notifies).
Active port setting is the setting actually in effect. For example, if the configured setting is
autoselect, the Active port setting will be the actual setting as autonegotiated with the client
device (computer, access point, hub, switch, etc.).
Supported settings lists the valid (supported) settings for the port. Any of these may be used
with the
set portmedia command for this port.
clear portmedia <port> | <slot>/<port>
Clears the port media setting for the specified port or slot and port. The setting reverts to
autoselect.
Access Controller Port Status Commands
The following commands are available only from an Access Controller or Integrated Access Manager.
show portip
Displays the current IP address and netmask settings, if set, for all ports in the system. Output from
this command is similar to the following:
Port settings
Slot 1 Port 1 IP: Not set
Slot 1 Port 2 IP: 192.168.5.1 Netmask: 255.255.255.0
Slot 1 Port 3 IP: 192.168.6.1 Netmask: 255.255.255.0
Slot 1 Port 4 IP: Not set
Slot 2 Port 1 IP: Not set
Slot 2 Port 2 IP: Not set
Slot 2 Port 3 IP: Not set
Slot 2 Port 4 IP: Not set
Slot 3 Port 1 IP: Not set
Slot 3 Port 2 IP: Not set
Slot 3 Port 3 IP: Not set
Slot 3 Port 4 IP: Not set