Management and Configuration Guide (Includes ACM xl) 2005-12

A-14 ProCurve Secure Access 700wl Series Management and Configuration Guide
Access Controller Configuration
The commands in this section are available only on an Access Controller or an Integrated Access
Manager. The exceptions are the
set accesscontrolserver, clear accesscontrolserver, and show
accesscontrolserver
commands, which are not available on an Integrated Access Manager. None of
these commands are available on a Access Control Server.
Note:
To disconnect an Access Controller from a Access Control Server, you must first change the
shared secret then the Access Control Server IP address. If you change the Access Control Server IP
address without changing the shared secret, the synchronization function between the Access Control
Server and the Access Controller will reset the Access Control Server IP address back to the original
Access Control Server IP address.
set accesscontrolserver <ip-address>
On an Access Controller, sets the IP address of its Access Control Server or Integrated Access
Manager.
Note: This command is not available on an Integrated Access Manager.
clear accesscontrolserver
On an Access Controller, clears the Access Control Server or Integrated Access Manager IP address.
Note: This command is not available on an Integrated Access Manager.
show accesscontrolserver
On an Access Controller, shows the current Access Control Server or Integrated Access Manager IP
address. Output from this command appears similar to the following:
Access Control Server: 192.168.2.15
Note: This command is not available on an Integrated Access Manager.
Advanced Network Configuration Status
show bridging
Shows the current bridging settings.
The current bridging types that may appear are:
For example, output from this command, if bridging is enabled, is similar to the following:
cdp Cisco Discovery Protocol
wnmp Wireless Network Access Protocol
atalk AppleTalk protocol
custom Type was set using a custom bridging string.
See “Bridging” in Chapter 6, and Appendix B, “Filter Expression Syntax” for a
detailed discussion.